IEC61000-3-2, 7.3.a 對于調光驅動電源測試要求的理解

如議題, IEC61000-3-2, 7.3.a 對于調光驅動電源測試要求的理解.標準要求如下:

7.3 Limits for Class C equipmenta) Active input power >25 WFor lighting equipment having an active input power greater than 25 W, the harmoniccurrents shall not exceed the relative limits given in Table 2.

However, the limits given in Table 1 apply to incandescent lighting equipment that hasbuilt-in dimmers or consists of dimmers built in an enclosure.

For discharge lighting equipment that has built-in dimmers or consists of independentdimmers or dimmers built in an enclosure, the following conditions apply:

– the harmonic current values for the maximum load condition derived from thepercentage limits given in Table 2 shall not be exceeded;

– in any dimming position, the harmonic current shall not exceed the value of currentallowed in the maximum load condition;

– the equipment shall be tested according to the conditions given in C.5.

對于調光驅動電源怎樣測試才是合格的?按此要求嗎?

However, the limits given in Table 1 apply to incandescent lighting equipment that hasbuilt-in dimmers or consists of dimmers built in an enclosure.

在標準中C5.3中又有這樣的要求?

If a luminaire has a built-in dimming device, the harmonic currents shall be measured at themaximum load of the lamps as specified by the manufacturer. The setting of the dimmingdevice is varied in five equidistant steps between the minimum and the maximum power inorder to obtain comprehensive results.

真的,讓人難以理解, 請各位親們幫幫手哦

dimming 100% 測試數據