Power supply for illumination applications

1、交流輸入

輸入電壓：85Vac - 265Vac 50/60Hz.

輸入過壓保護(hù)

功率因素>0,8 for output power 0,3w to full power (PFC is mandatory)
 No ground cable allowed.
2、直流輸出

輸出電壓： 10Vdc±10%

最大紋波電壓：0,5V

最大輸出功率：6W (600mA)

最小輸出功率：0,3W (30mA) à PF >0,8（非常重要）

允許永久短路

效率：>75% at full output power
>60% alt minimum output power. If this requirement is very difficult, it possible to reduce to >40%.
3、電氣絕緣

o AC to DC insulation strength: 3000V 50Hz 1 min.
o Insulation resistance: >4M? at 500Vdc
爬電距離 > 5mm
o No capacitors (Y1, Y2, etc) allowed between AC and DC
- MTBF: >150Khrs@40oC
適用標(biāo)準(zhǔn)

o UNE-EN 55015: 2007 + A1:2008 + A2:2009
o UNE-EN 61000-3-2: 2006 + A1:2009 + A2:2009 (type C for illumination)
o UNE-EN 61547: 1997 + A1:2001
§ UNE-EN 61000-4-2: 2009
§ UNE-EN 61000-4-3: 2007 + A1:2008 + A2:2009
§ UNE-EN 61000-4-4: 2005 + A1:2010 + Corr.: 2010
§ UNE-EN 61000-4-5: 2007 + Corr.: 2010
§ UNE-EN 61000-4-6: 2009
§ UNE-EN 61000-4-8: 2010
§ UNE-EN 61000-4-11: 2005
- Connections to main board using metallic poles. The positions of metallic poles Hill be where required.
- 尺寸大?。?/SPAN>50mm x 40mm x 15mm(h). 高度最高不得超過18mm.

It′s very important de power factor, I need higher than 0,8 at 0,3w power to full power (6W). The oder important think is the standard. I need to comply the standard, specially the harmonics standard UNE-EN 61000-3-2 class C, below 25W.

Send me the quote of the power supplies in quantities of: 2K, and 50K 10K.